led-40w seriesC fixed output and dimmable switch mode led drivers constant current & constant voltage with isolation black magic thermal advantage? plastic housing ordering options: -d: 2-wire dimmable model dims 100% to 10%. two extra wires included on the output side: +purple/-gray. this model is offers 0-10v & resistance dimming, compatible with most quality 0-10v dimmers. see page 3. -d3: 3-wire dimmable model dims 100% to 10%. three extra wires included on the output side: yellow/purple/gray. this model is suitable for potentiometer dimming. see page 3. electrical specifcations input voltage range: 100-277 vac nom. (90-305 v min/max) input over-voltage: can endure 320vac for 48 hrs, 350vac for 2 hrs frequency: 50/60 hz nom. (47-63 hz min/max) power factor: >0.90 @ full load, 100v through 277v inrush current: <20.0 amps max @ 230 vac, cold start 25oc input current: 0.40 amps max maximum power: 40w current accuracy: 1% over input line variation load regulation: 3% thd: <_ 20% @ full load leakage current: 400 a typical hold up time: half cycle output protection: over-voltage, over-current, and short circuit protection with auto recovery environmental specifcations maximum case temp. 90c minimum starting temp: -30oc storage temperature: -40oc to +85oc humidity: 5% to 95% cooling: convection vibration frequency: 5 to 55 hz/2g, 30 minutes sound rating: class a mtbf: 482,000 hours at full load and 40oc ambient conditions per mil-217f notice 2 emc: fcc 47cfr part 15 class b compliant constant current - product specifcations model number output current (ma 5%) output voltage range (vdc) max output power (w) max effciency led40w-114-c0350- xx 350 38-114 40 87% led40w-100-c0400- xx 400 33-100 40 87% led40w-089-c0450- xx 450 30-89 40 87% led40w-054-c0700- xx 700 18-54 37.8 86% led40w-048-c0830- xx 830 16-48 40 86% led40w-045-c0900- xx 900 15-45 40 86% led40w-040-c1000- xx 1000 13-40 40 85% led40w-036-c1100- xx 1100 12-36 40 86% led40w-030-c1300- xx 1300 10-30 39.0 86% led40w-030-c1400- xx 1400 10-30 42 85% led40w-024-c1300- xx 1300 8-24 31.2 86% led40w-024-c1400- xx 1400 8-24 33.6 86% led40w-024-c1670- xx 1670 8-24 40 86% led40w-022-c1820- xx 1820 7-22 40 86% led40w-018-c2220- xx 2200 6-18 40 85% led40w-015-c2680- xx 2680 5-15 40 85% led40w-013-c3080- xx 3080 4-13 40 85% led40w-012-c3330- xx 3330 4-12 40 84% led40w-010-c4000- xx 4000 3-10 40 84% led40w-009-c4450- xx 4450 3-9 40 83% constant voltage - product specifcations model number output voltage (vdc 5%) output current range (ma) max output power (w) max effciency led40w-009 9 1113-4450 40 83% led40w-010 10 1000-4000 40 84% led40w-012 ? 12 833-3330 40 84% led40w-013 13 770-3080 40 85% led40w-015 15 670-2680 40 85% led40w-018 18 550-2200 40 85% led40w-022 22 455-1820 40 86% led40w-024 ? 24 418-1670 40 86% led40w-030 30 350-1400 42 85% led40w-036 36 275-1100 40 86% led40w-040 40 250-100 40 85% led40w-045 45 225-900 40 86% led40w-048 48 208-830 40 86% led40w-054 54 175-700 40 86% led40w-089 89 113-450 40 87% led40w-100 100 100-400 40 87% led40w-114 114 88-350 40 87% class 2: us/canada -xx indicates dimming options are available. see options below. blank = fxed current output e332160 sign components manual rev 10-13-16 ? total power: 40 watts ? input voltage: 100-277 vac ? ul dry & damp location rated ? ip66 & nema4 ? high power factor ? ul sign components manual (s.a.m. models) ? indicates s.a.m. specifcations subject to change without notice. note: led drivers are designed and intended to operate led loads only. non-led loading may be outside the specifed design limits of our led drivers, and therefore cannot be covered by any warranty. if you desire to use our led drivers to operate non-led loads please contact us to discuss compatibility. thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com
pg 2 of 3 dimensions - in [mm] ul conditions of acceptability see website for additional information input white (n) black (l) dimming purple (+) gray (-) 2.76 [ 70.0 ] 0.2 [ 5.0 ] 0.16 [ 4.0 ] 1.85 [ 47.0 ] 0.16 [ 4.0 ] 5.91 min [ 150 min ] 5.91 min [ 150 min ] 0.39 [ 10.0 ] 0.39 [ 10.0 ] 0.390.04 [ 10.01 ] 0.390.04 [ 10.01 ] 1.18 [ 30.0 ] 1.18 [ 30.0 ] 3.74 [ 95.0 ] 1.26 [ 32.0 ] tc = 90c max output red (+) blue (-) wire specs: input leads: 18 awg, rated 600 v, 105c, min. output leads: 18 awg, rated 300 v, 105c, min. dimming leads: 22 awg, rated 300 v, 105c. all wires are stranded with solder dipped ends. 50% load pf power factor / load (led40w rev e1.1 models) 60% 70% 80% 90% 100% 50% load thd thd / load (led40w rev e1.1 models) 60% 70% 80% 90% 100% 1 20v a c 2 77v a c 1 20v a c 2 77v a c 0.50 0.55 0.70 0.65 0.60 0.75 0.90 0.85 0.80 0.95 1.00 0% 15% 10% 5% 20% 25% typical efficiency / load (led40w rev e1.1) 75% 70% 80% 85% 90% 100% 95% load efficiency 60% 70% 80% 90% 100% 1 20v a c 2 77v a c 45 case hotspot temperature (c) lifetime (khrs) lifetime / case temperature 0 60 90 115 75 15 30 45 130 50 55 60 65 70 75 80 85 90 led40w series note: e e e te eteete e eeet ee te e has highly reliable operation within specifcation. driver performance may drift out of published specifcations as the hours of operation exceed the curve at a given temperature. higher operating temperatures increase the chances of a failure to function. driver lifetime but are not represented in this calculation. safety cert. standard ul/cul ul8750 csa 22.2 ce en61347 emc standard notes en61000-3-2 en61000-3-3 class c fcc, 47cfr part 15 class b en6100-4-5 2kv l-n, 8/20 sec surge protection ssl solutions faster than the speed of light ? thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com
pg 3 of 3 notes: 1. d dimmable version comes with an extra two wires on the output side: +purple/-gray. 2. compatible with most 0-10v dimmers. recommended dimmer is leviton ip710 or equivalent. 3. d & d3 dimmable versions are not intended to dim below about 5% @ 0v or 10% @ 1.0v. 4. output will be 100% with purple/gray open and minimum with purple/gray shorted. parameters minimum typical maximum source current out of 0-10v purple wire 0 ma - 2 ma absolute voltage range on 0-10v (+) yellow wire -2.0 v - +15 v source current out of aux yellow wire - - 10ma dim (+) purple ip710 wall dimmer ?-d? typical dimming circuit led40w- xxx-cxxxx -d dim (-) gray ?-d3? 3-wire dimming circuit led40w-xxx-cxxxx-d3 20k potentiometer 10v output (yellow) 0-10v input (purple) return (gray) (dimmer must be current-sink type control) -d and -d3 option: 0-10vdc and resistance dimming 0v 1v 2v 3v 4v 5v 6v 7v 8v 9v 10v purple-to-gray voltage ( v dc) o u t put c u rre n t / 0 - 1 0 v dc d i mmi ng control voltage 0 1 0 2 0 3 0 4 0 5 0 6 0 7 0 8 0 9 0 100 outpu t cu rr ent % led40w series ssl solutions faster than the speed of light ? thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com
|
